U3555 BMW Fault Code

Description:

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

U3555 Code Symptoms :

The U3555 Check Engine lamp is perhaps the most troubling of lights because it could mean so many different things, from you didn't screw the gas cap on tightly enough to look out for pistons flying through the hood and into the stratosphere. The easiest way to find out what this light is telling you is to hook your vehicle up to a scan tool. U3555 diagnostic tool looks a little like an oversized calculator and plugs into a communication port inside the car. After you instruct it to perform the scan, it speaks with your car's computers to find out exactly what's prompting the light to turn on.

Diagnosis And Repairing U3555

U3555 OBD2 may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.

How to fix U3555 code ?

• Camshaft advance mechanism binding (VCT unit)
• Faulty Variable Camshaft Timing (VCT) position solenoid
• Incorrect Positive Crankcase Ventilation (PCV) hose connection
• Foreign matter caught in fuel filler cap

In most cases, the TCM is integrated into a single housing with the BMW PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately.

In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.